Connecting through USB? Set up an RS422 serial reader →
1 · CHOOSE A READER
Which reader are you connecting?
Configure and enable an IP reader in your backend, sync the controller configuration, then choose Refresh setup.
Device reference
2 · CONFIGURE YOUR HARDWARE
Enter these settings on the reader
- Reader IP address
- —
- Controller / server address
- —
- Controller TCP port
- —
Use a compatible ACS IP reader. Set its address to the one above, or change the reader address in your backend, sync the controller configuration and refresh this page.
The reader needs a network connection to this Pi. The simulator's web address is for your browser.
3 · SELECT HOW TO USE IT
Switch the selected reader
Disconnect the real reader from the controller before switching. Virtual IP readers briefly reconnect while the change is applied. Your dashboard stays open.
4 · CONNECT AND TEST
Tap a real card
- After selecting Physical reader, connect the hardware using the settings above.
- Choose Refresh setup to check its TCP connection. Confirm heartbeat, reader status and card results in Diagnostics.
- Tap a permitted card. The controller decides access and drives the simulated lock.
- Return to Doors & readers to open and close the simulated door, or run a door scenario.
A TCP connection alone does not confirm reader compatibility or a successful card transaction. Virtual card, PIN and tamper buttons are disabled for physical readers.
Open Doors & readers →