← Physical readers

USB READER SETUP

RS422 serial reader

Connect a real ACS reader through a USB-to-RS422 converter.

Diagnostics

1 · CHOOSE A BUS

Which reader bus?

Readers affected by this selection

    This first cut replaces every virtual reader on the selected bus. Other reader buses and door boards keep running. Start with one physical reader on a dedicated test bus.

    2 · CONNECT THE CONVERTER

    USB-to-RS422 adapter

    1. Use an RS422 converter with separate transmit and receive pairs. Match its pinout to the reader manual.
    2. Supply the reader's specified voltage and current. USB power to a converter does not necessarily power the reader.
    3. Set the reader to the serial settings and an enabled address listed here. It must support the ACS reader protocol.
    4. Plug the converter into this Pi and choose Refresh setup. USB detection alone cannot identify its electrical interface.

    3 · SELECT TRANSPORT

    Apply the bus selection

    4 · VERIFY REAL COMMUNICATION

    Connection check

    Reader service
    —
    USB connection
    —
    Recent valid reader replies
    —
    Bytes forwarded to / from reader
    —

    Choose Refresh setup to update these observations. Valid replies show serial traffic, not a successful access transaction. Tap a real card and check the controller decision, simulated lock and backend transaction.

    If USB is unplugged, this bus stays physical and waits for the same adapter. It never falls back to fake replies. Virtual card, PIN, tamper and reader outage inputs are disabled.

    Open Doors & readers →